Renthal Kevlar Half-Waffle Grips
MSRP: $24.95
$19.96
Exact Fitment Guarantee
The Renthal Kevlar Half-Waffle Grips represent the pinnacle of motocross grip technology, blending the ultra-soft feel of a competition grip with the extreme longevity of composite engineering. Standard grips force riders into an unpleasant compromise: soft rubber compounds offer superb traction and vibration damping but wear out in a handful of motos, while hard compounds last all season but cause severe palm blistering and arm pump. Renthal solved this dilemma by infusing millions of microscopic DuPont Kevlar aramid resin particles into their proprietary thermoplastic elastomer matrix.
As the grip is used, the outer elastomer matrix gently wears, continuously exposing more Kevlar particles at the contact surface. The result is a grip that feels luxuriously soft and tacky in dry, wet, or muddy conditions while outlasting standard soft-compound grips by up to three times. The classic Half-Waffle pattern combines a smooth, diamond-knurled upper half that maximizes palm surface contact with a traditional waffle grid on the lower half that gives fingertips positive mechanical purchase when pulling against acceleration forces.
- Material Composition: Thermoplastic elastomer infused with microscopic DuPont Kevlar aramid particles
- Pattern: Dual-surface Half-Waffle (Diamond knurl upper / Waffle grid lower)
- Hardness / Durometer: Ultra-soft base feel with progressive Kevlar particle wear resistance
- Diameter Compatibility: Fits all standard 7/8" (22.2mm) handlebars and 1" (25.4mm) throttle tubes
- Safety Features: Integrated safety wire grooves at inner flange, center, and outer edge
### Step-by-Step Installation & Safety Protocols Installation requires thorough preparation. Carefully cut away the old grips using a razor blade, taking care not to gouge the plastic throttle tube or aluminum handlebar. Clean both surfaces with isopropyl alcohol or brake cleaner until completely free of old adhesive residue. Apply a continuous coat of Renthal Grip Glue to both the inside of the grip and the handlebar surface. Slide the grip on in one smooth, continuous motion, aligning the waffle section to the underside where your fingers curl. Ensure the grip flange is seated flush against the inner housing. Allow the adhesive to cure for at least 8 hours, then install stainless steel safety wire around the dedicated grip wire grooves (two to three wraps per groove, twisting and burying the wire pigtails into the rubber) to prevent slippage in wet conditions.
### Maintenance & Grip Longevity Maintenance involves washing grips with regular soap and water after riding. Avoid soaking grips in petroleum solvents, degreasers, or chain lube, which degrade thermoplastic compounds.
Frequently Asked Questions
Q: Why do Renthal Kevlar grips have a unique natural beige color?
A: The distinctive light tan/beige color is the natural hue of raw DuPont Kevlar aramid fibers embedded within the transparent elastomer base without artificial color dyes.
Q: Do I have to use safety wire with these grips?
A: While Renthal Grip Glue provides a powerful chemical bond, safety wiring grips in the designated recessed grooves is highly recommended for all motocross and off-road riding to ensure grips never rotate under wet or muddy conditions.
Q: How do Kevlar grips help reduce arm pump?
A: Because the compound is exceptionally soft and tacky, riders can maintain total control with lighter grip pressure, dramatically reducing muscular forearm tension and mitigating arm pump.
Q: How many hours of riding do Renthal Kevlar grips typically last?
A: Under normal motocross conditions, riders typically achieve 30 to 50 operating hours before significant waffle wear occurs, roughly triple the lifespan of standard soft-compound grips.