D.I.D VT2 X-Ring Enduro Chain 520

The D.I.D 520 VT2 X-Ring Enduro Gold Chain (Enduro Narrow Series) is the ultimate heavy-duty sealed drive chain engineered specifically for off-road, enduro, cross-country, and dual-sport motorcycles. Many standard sealed O-ring chains are too wide for compact motocross-based enduro chassis, causing the chain side plates to rub against the engine case, front chain guide, or rear tire. D.I.D solved this clearance issue by designing the VT2 with a specialized narrow profile that delivers all the longevity of a sealed chain within the slim width of a non-O-ring chain.

The core technology of the VT2 is D.I.D's patented X-Ring seal architecture. Unlike traditional round O-rings that experience high surface friction and squash flat under tension, the X-Ring features four flexible contact lips that twist rather than squash, reducing mechanical drag by 50% while creating four independent sealing barriers that lock high-viscosity factory grease inside the pin-bushing junction. This completely seals out abrasive sand, water, and mud, extending chain wear life by up to 1.5 to 2 times compared to standard O-ring chains. The gold-plated outer links provide excellent corrosion resistance against stream crossings and wet trail conditions.

• Chain Pitch: 520 Narrow Series (Engineered for compact off-road swingarm clearances)
• Sealing Technology: Patented D.I.D low-friction X-Ring elastomer seals
• Tensile Rating: 8,440 lbs (37.5 kN)
• Frictional Drag: 50% less resistance compared to standard round O-ring chains
• Master Link: Semi-press fit clip-type master link with gold side plates

### Step-by-Step Installation & Safety Protocols Installation is performed with a 520 chain breaker and link press tool. Determine appropriate chain length, cut the chain to size, and align the chain ends over the rear sprocket. Thoroughly coat the four X-rings with the supplied high-tack grease and place two rings over the master link pins. Insert the master link from the back of the chain, install the remaining two greased X-rings, and press the outer side plate into position using a chain press tool. Secure the included semi-press clip master link with the closed end oriented forward in the direction of travel. Set chain slack to 50-55mm to prevent swingarm binding during deep suspension compression.

### Maintenance & Wash Guidelines Maintenance involves washing with a gentle chain brush, rinsing with low-pressure water (never direct a high-pressure pressure washer directly at the X-rings), drying, and spraying with O-ring-safe chain lubricant.

Frequently Asked Questions